Product Description

Trade Show Exhibit Display Booth Sys048

Trade Show Exhibit Display Booth 20×20 F34-501FS
20-Foot Crossover Truss Trade Show Booth – X Truss Design

Engineering Report Available, Enquire About Costs
Custom Powder Coat Finishes Available Upon Request
Smaller Truss Segment Lengths Available Upon Request

The truss booth system can typically be set-up by three to four people who are familiar with the truss booth system and the only tool required would be a steel hammer.

The truss booth can be expanded to a larger size by adding additional pieces from our F34 Square Aluminum Truss series. Our line of 50mm 1.96″ – Clamps were specifically developed for this truss system.

STRUCTURE HAS BEEN DESIGNED FOR A MAXIMUM RIGGING LOAD OF 150 POUNDS PER LINEAR FOOT. THE STRUCTURE HAS BEEN DESIGNED FOR A MAXIMUM RIGGING LOAD OF 75 POUNDS PER LINEAR FOOT ON EACH OF THE FOUR SPANS APPLIED ONLY TO THE BOTTOM CHORD. THE STRUCTURE HAS BEEN DESIGNED FOR A MAXIMUM RIGGING CENTER POINT LOAD OF 2800 POUNDS SHARED EQUALLY BETWEEN 4 POINTS. POINT LOAD IS NOT CONCURRENT WITH LINEAR LOADING. RIGGING ASSUMES NO BRIDLING. THE STRUCTURE REQUIRES 450-LBS. BALLAST ON EACH CORNER OR ANCHORAGE TO CONCRETE SLAB.Do not exceed the load capacity of the F34 Truss Booth System. The F34 Truss Booth System should be fully inspected before use. In the occurrence of any damage or defect, the F34 Truss Booth System should not be used. The use of sand bags is recommended for maximum security.