Trade Show Exhibit Display Booth 10×20 F34-201
10′ x 20′ Truss Trade Show Booth – Re-Configurable F34 Square Truss Kit
Truss Booth can be used as a small island booth or inline booth.
Truss Booth is modular and can be set up in 4 different configurations.

Engineering Report Available, Enquire About Costs
Custom Powder Coat Finishes Available Upon Request
Smaller Truss Segment Lengths Available Upon Request

Aluminum Truss is usually very lightweight can be transported in collapsible containers or truss bags.

The truss booth system can typically be set-up by three to four people who are familiar with the truss booth system and the only tools required would be a steel hammer, and M10 Hex Allen Wrench Key.

The truss booth can be expanded to a larger size by adding additional pieces from our F34 Square Aluminum Truss series. Our line of 50mm 1.96″ – Clamps were specifically developed for this truss system.

STRUCTURE HAS BEEN DESIGNED FOR MAX RIGGING OF 200 POUNDS PER LINEAR FOOT ON 10-FOOT SPAN, MAX RIGGING OF 120 POUNDS PER LINEAR FOOT ON 20-FOOT SPAN. RIGGING ASSUMES NO BRIDLING. WHEN USING A REAR SCRIM, THE STRUCTURE REQUIRES 1400-LBS. BALLAST ON EACH CORNER OR ANCHORAGE TO CONCRETE SLAB. Do not exceed the load capacity of the F34 Truss Booth System. The F34 Truss Booth System should be fully inspected before use. In the occurrence of any damage or defect, the F34 Truss Booth System should not be used. The use of sand bags is recommended for maximum security.

Specificaions:

• Trade Show Exhibit Display Booth 10×20 F34-201
• You Create 4 Different Booth Configurations
• In-Line 10×20 Truss Trade Show Booth
• Lightweight Square Truss assembles in minutes with the use of a Steel Hammer
• Max Load of 200-Lbs. Per Linear Foot On 10-Foot Span, Max Load of 120-Lbs. Per Linear Foot On 20-Foot Span.
• 9.84-foot Overall Truss Booth Width
• 19.68-foot Overall Truss Booth Length
• 9.97-foot Overall Truss Height
• General Truss Information
  • F34 Square Aluminum Truss
  • 11 7/16″ 290mm Overall Truss Width
  • 2″ 50mm Outer Diameter Tubing
  • 3/4″ 20mm Diagonal Bracing
  • 0.08″ 2mm Wall Thickness
  • Approximate Weight – 450 Lbs.
  • Connecting Hardware Included
  • Aluminum Brush Finish