Trade Show Exhibit Display Booth 10×20 F23-201
10′ x 20′ Truss Outdoor Dining Tent System – Re-configurable Triangular Truss Kit
Trade Show Exhibit Display Booth uses F23 Triangular Aluminum Truss.

Custom Powder Coat Finishes Available Upon Request
Smaller Truss Segment Lengths Available Upon Request

The truss booth system can typically be set-up by three to four people who are familiar with the truss booth system and the only tool required would be a steel hammer.

Our line of 35mm 1.37″ – Clamps were specifically developed for this truss system. Truss Booth can be used as a small island booth or inline booth.

Do not exceed the load capacity of the F23 Truss Booth System. The F23 Truss Booth System should be fully inspected before use. In the occurrence of any damage or defect, the F23 Truss Booth System should not be used. The use of sand bags is recommended for maximum security.

Specificaions:

• Trade Show Exhibit Display Booth 10×20 F23-201
• In-Line 10×20 Truss Trade Show Booth Lightweight Triangular Truss assembles in minutes with the use of a Steel Hammer
• 9.84-foot Overall Truss Booth Width
• 19.64-foot Overall Truss Booth Length
• 9.84-foot Overall Truss Booth Height
• General Truss Information
  • F23 Triangular Aluminum Truss
  • 8.66″ 220mm Truss Overall Width
  • 1.37″ 35mm Truss Outer Diameter Tubing
  • 0.32″ 8.30mm Truss Diagonal Bracing
  • 0.078″ 2mm Truss Wall Thickness
  • Approximate Weight – 200 Lbs.
  • Connecting Hardware Included
  • Aluminum Brush Finish