Trade Show Exhibit Display Booth 10×10 F34-901
10-Foot Crossover Truss Trade Show Booth with Circular Arches

Custom Powder Coat Finishes Available Upon Request
Smaller Truss Segment Lengths Available Upon Request

Aluminum Truss is usually very lightweight and can be transported in collapsible containers or truss bags.

The truss booth system can typically be set-up by two to three people who are familiar with the truss booth system and the only tool required would be a steel hammer.

The truss booth can be expanded to a larger size by adding additional pieces from our F34 Square Aluminum Truss series. Our line of 50mm 1.96″ – Clamps were specifically developed for this truss system.

Do not exceed the load capacity of the F34 Truss Booth System. The F34 Truss Booth System should be fully inspected before use. In the occurrence of any damage or defect, the F34 Truss Booth System should not be used. The use of sand bags is recommended for maximum security.

Specificaions:

• Trade Show Exhibit Display Booth 10×10 F34-901
• 10' × 10' Truss Trade Show Booth Crossover Design with Circular Arches
• Lightweight Square Truss assembles and dismantles in minutes with the use of a Steel Hammer
• 10-foot Overall Truss Booth Width
• 10-foot Overall Truss Booth Length
• 9.84-foot Overall Truss Booth Height
• General Truss Information
  • F34 Square Aluminum Truss
  • 11 7/16″ 290mm Overall Truss Width
  • 2″ 50mm Outer Diameter Tubing
  • 3/4″ 20mm Diagonal Bracing
  • 0.078″ 2mm Wall Thickness
  • Approximate Weight – 308 Lbs.
  • Connecting Hardware Included
  • Aluminum Brush Finish