In-Line 10×10 Truss Booth with Dual Tier Circle with Modular F33 Triangular Trusses.

Custom Powder Coat Finishes Available Upon Request
Smaller Truss Segment Lengths Available Upon Request

The truss booth system can typically be set-up by three to four people who are familiar with the truss booth system and the only tool required would be a steel hammer.

The truss booth can be expanded to a larger size by adding additional pieces from our F33 Triangular Aluminum Truss series. Our line of 50mm 1.96″ – Clamps were specifically developed for this truss system.Truss Booth can be used as a small island booth or inline booth.

Do not exceed the load capacity of the F33 Truss Booth System. The F33 Truss Booth System should be fully inspected before use. In the occurrence of any damage or defect, the F33 Truss Booth System should not be used. The use of sand bags is recommended for maximum security.

Specificaions:

• In-Line 10′ x 10′ Truss Booth with Dual Tier Circle
• Lightweight Square Truss constructs in minutes with the use of a Steel Hammer
• Max Load of 140-Lbs. Per Linear Foot On Each Span
• 9.84-foot Overall Truss Booth Width
• 9.84-foot Overall Truss Booth Length
• 13.94-foot Overall Truss Booth Height
• General Truss Information : F33 Triangular Aluminum Truss, 11 7/16″ 290mm Overall Truss Width, 2″ 50mm Outer Diameter Tubing, 3/4″ 20mm Diagonal Bracing, 0.078″ 2mm Wall Thickness
• Approximate System Weight : 593 Lbs.
• Connecting Hardware Included, Aluminum Brush Finish