10-Foot Trade Show Truss Booth – Custom Exhibit Booth Displays

Complete Modular Trade Show Exhibit Display Booth uses F24 Square Aluminum Truss. 10′ x 10′ 4 Leg Truss Trade Show Booth is EXCELLENT for any company that needs a UNIQUE real trade show presence. Aluminum Truss is usually very lightweight and can be transported in small custom cases or truss bags.

Engineering Report Available, Enquire About Costs
Custom Powder Coat Finishes Available Upon Request
Smaller Truss Segment Lengths Available Upon Request

The truss booth system can typically be set-up by two to three people who are familiar with the truss booth system and the only tool required would be a steel hammer.

The truss booth can be expanded to a larger size by adding additional pieces from our F24 Square Aluminum Truss series. Our line of 35mm 1.37″ – Clamps were specifically developed for this truss system. Truss Booth can be used as a small island booth or inline booth.

STRUCTURE HAS BEEN DESIGNED FOR MAX RIGGING OF 160 POUNDS PER LINEAR FOOT ON EACH SPAN. RIGGING ASSUMES NO BRIDLING. WHEN USING A REAR SCRIM, THE STRUCTURE REQUIRES 800-LBS. BALLAST ON EACH CORNER OR ANCHORAGE TO CONCRETE SLAB. Do not exceed the load capacity of the F24 Truss Booth System. The F24 Truss Booth System should be fully inspected before use. In the occurrence of any damage or defect, the F24 Truss Booth System should not be used. The use of sand bags is recommended for maximum security.

Specificaions:

• 10×10 Trade Show Truss Booth Lightweight Square Truss constructs in minutes with the use of a Steel Hammer
• Max Load of 160-Lbs. Per Linear Foot On Each Span
• 9.84-foot Overall Truss Booth Width
• 9.84-foot Overall Truss Booth Length
• 9.84-foot Overall Truss Booth Height
• General Truss Information : F24 Square Aluminum Truss, 8.66″ 220mm Truss Overall Width, 1.37″ 35mm Truss Outer Diameter Tubing, 0.32″ 8.30mm Truss Diagonal Bracing, 0.078″ 2mm Truss Wall Thickness
• Approximate System Weight – 180 Lbs
• Connecting Hardware Included : Aluminum Brush Finish